Influence of corrosion crack patterns on the rate of crack widening of RC beams
Journal article
Authors/Editors
Research Areas
No matching items found.
Publication Details
Author list: Malumbela G, Moyo P, Alexander M
Publisher: Elsevier
Place: OXFORD
Publication year: 2011
Journal: Construction and Building Materials (0950-0618)
Journal acronym: CONSTR BUILD MATER
Volume number: 25
Issue number: 5
Start page: 2540
End page: 2553
Number of pages: 14
ISSN: 0950-0618
eISSN: 1879-0526
Languages: English-Great Britain (EN-GB)
View in Web of Science | View on publisher site | View citing articles in Web of Science
Abstract
Corrosion crack widths are often used by structural engineers in the field to predict level of steel corrosion as well as residual load-bearing capacities of corroding RC structures. This paper presents further work on this matter but with focus on corrosion crack patterns and how they affect rate of crack widening. It is based on results from a research where 17 quasi-full-scale (153 x 254 x 3000 mm) RC beams were corroded under various levels of sustained loads. The rate of widening of corrosion crack widths was found to be very much dependent on crack patterns. Deformation of cover concrete under each crack pattern was discussed. It was found that at maximum crack widths below 0.6 mm, the majority of beams exhibited nearly similar crack patterns as well as rate of widening of corrosion cracks. A mass loss of steel of 1% corresponded to a maximum crack width between 0.14 and 0.22 mm. At large crack widths (> 0.6 mm), various beams exhibited very different rates of crack widening. It was shown that at crack widths above 0.6 mm, to be conservative an increase in mass loss of steel of 1% corresponded to corrosion crack widening of 0.02 mm. (C) 2010 Elsevier Ltd. All rights reserved.
Keywords
Crack patterns, Crack widths, Reinforced concrete, Steel corrosion
Documents
No matching items found.
